Stuie
Husqvarna
C Class
G'Day all, I just got a 2012smr 511 it's black too so I reckon it's tough. I've had it a week, done just under 900 mm. I hooked up with cafe husky weeks before though and for everyone that's already helped me by reading the posts, I say a big thank you, from running in on mineral oils, to oily air boxes and even adjusting my gear lever ( which I found a very enjoyable task ), I love everything about this bike.. I've never had a road bike, my last trail bike was over 20 years ago an it was an Ag bike, that's right but I got all d right attributes to own this bike. It's hard to stay off it. I never believed anything could b as much fun. I am enjoying tweaking this bike and will always want to learn more about it and slowly get better doing it ultimately getting the best from this machine, things in the future I wanna b able to do is the valve check an so forth but at the moment I've loved doing all the oil changes to run it in and until I understand the bike, it's chips or electronics then I'll just continue playing around without, I might even b able to give some hard learnt advice ( doubtful though ), last night I shortened the front indicators,they look ok, they don't stick out as much.
I'm trying this first thread because I'm searching for advice.
I'm taking the majority of peoples advice and fitting a pipe next week so I just wanna make sure what I'm getting is the best available for this bike. Of course it's an Akropovic hopefully full titanium, but here's my dilemma, I'm under the impression that the one specifically built for this model is not actually the best one for performance, or to fit. I'm posting this because I know no better but I'm under the impression the te510 has a power up pipe or similar, some I'm asking one of you genius out there who has all the knowledge I need to know an with luck can even send me the product codes cause at the moment Im a wooduck that's probably going to buy it without any knowledge but with all the enthusiasm to hear what this bike really should sound like. Also if possible, what my instrument panel should say once it's mapped to the pipe, now for some reason it says map2..I did tell them to remove the LAMS restrictor??? Again I don't know the specifics when I bought it but was only aware they disconnected a wire under my seat, see I'm not even too sure it's running 100% output now..thanks again for cafe husky.. Jeez these bikes are soo much fun..
I'm trying this first thread because I'm searching for advice.
I'm taking the majority of peoples advice and fitting a pipe next week so I just wanna make sure what I'm getting is the best available for this bike. Of course it's an Akropovic hopefully full titanium, but here's my dilemma, I'm under the impression that the one specifically built for this model is not actually the best one for performance, or to fit. I'm posting this because I know no better but I'm under the impression the te510 has a power up pipe or similar, some I'm asking one of you genius out there who has all the knowledge I need to know an with luck can even send me the product codes cause at the moment Im a wooduck that's probably going to buy it without any knowledge but with all the enthusiasm to hear what this bike really should sound like. Also if possible, what my instrument panel should say once it's mapped to the pipe, now for some reason it says map2..I did tell them to remove the LAMS restrictor??? Again I don't know the specifics when I bought it but was only aware they disconnected a wire under my seat, see I'm not even too sure it's running 100% output now..thanks again for cafe husky.. Jeez these bikes are soo much fun..