not husky...Moto Villa!!

already for a good scrub and send off for rechroming

Suprize,

Who are you using for the hard chroming and how much were you quoted?

My mate has a DT360 he is restoring and the forks need doing.

I emailed radchrome....their reply...


Cost is $340 for the pair. Straightening is extra if required.


www.radhardchroming.com.au
like their direct response

got to make a start on the rubberband....pulled the kicker off (neat external spring arrangement)and the clutch cover.

snuck the allen head screws out with some assistance of a "lever". found a small washer on the kick shaft fell off, then the clutch "bearing" dropped a ball into the box but I saved it with a maggy screwdriver . Really neat clutch actuator.

Got Rad to do all my Husky forks and am very happy with the job.

This popped up on fakebook today, a little inspiration perhaps JC?

suuuwweeet.

The fastening arrangement for the springs looks like a CZ. Motor looks good inside.

well ...the cases are split and the news is not good the old top half of the gears that were out of the oil are pitted and corroded trick which is unfortunate. 3rd and 4th have deepish pits through the hard facing and the main shaft gear is also pooh. the shifting dogs are worn (go on?) and the gear dogs are rounded badly. the main bearings are crunchy but the rod and big end are good TC. so the hunt for bits begins...ill get some pics up shortly...

here are some pics

couple more...

Bummer!

got a mate who is a gear cutter etc so he his happy to have a look. hoping he can sort the gears and the dogs out ok. just need the main clutch shaft or get that gear repaired as well.

some things to do.

just picked up some work in the mountains on an old gold mine so backburner for all this "stuff". At least I'll make some "coin" to pay for stuff

I work for myself and when there's work that's what you do. I'm a bit busy as well.

moto villa for sale
in belgium and italy

250 SIMONINI with front forks CORTE et COSSO
for sale ............................in SWEDEN ??

cool... the wedding is over and im back at work. the fork tubes are packaged to post up to the rechromers, ive sent a few emails here and there for parts and ill be looking to get a friendly gearcutter to make a few rusty gears after xmas...it underway again

Looks like a fine bike when all done!

Be worth it!