Giack Husky310R
Husqvarna
AA Class
Hi to all Cafe Husky users,
I'm having some problems with the hot starts of the 310R; in the beginning of this year I was lucky enough to find a oem Husky GET ECU for a TC250 2013 (red cdi) and to have a shop load a map for the 310.
Bike runs good and starts fine cold on the very first kick but when I need to restart (hot engine) there is no chance of it firing with the kicker and the e-start takes some rivolution to start (too many against what I was used to the with the OEM CDI).
To give the complete picture before the GET cdi I had the OEM keihin CDI running on map3 and the power commander and the hot start was not a issue, I could immediatly restart with one or two kicks, e-start was also quite immediate. I've already checked valve clearences ad set the left that operates on the decompressor a little below 0,20, TPS is set at 650 mV and idle is above 2200 rpm (for e-start I also have a 245 CCA battery and it spins fast).
With the ECU they gave me the VT1 programmer that allows you to edit in a small range the % of fuel, set tps value and adjust the advance.
What parameter you think I can change with the VT1 to improve the hot start or what other things I should trace to be able again to hot start it with the kickstart (obviously without going back to stock because the power gain is notable)
I'm having some problems with the hot starts of the 310R; in the beginning of this year I was lucky enough to find a oem Husky GET ECU for a TC250 2013 (red cdi) and to have a shop load a map for the 310.
Bike runs good and starts fine cold on the very first kick but when I need to restart (hot engine) there is no chance of it firing with the kicker and the e-start takes some rivolution to start (too many against what I was used to the with the OEM CDI).
To give the complete picture before the GET cdi I had the OEM keihin CDI running on map3 and the power commander and the hot start was not a issue, I could immediatly restart with one or two kicks, e-start was also quite immediate. I've already checked valve clearences ad set the left that operates on the decompressor a little below 0,20, TPS is set at 650 mV and idle is above 2200 rpm (for e-start I also have a 245 CCA battery and it spins fast).
With the ECU they gave me the VT1 programmer that allows you to edit in a small range the % of fuel, set tps value and adjust the advance.
What parameter you think I can change with the VT1 to improve the hot start or what other things I should trace to be able again to hot start it with the kickstart (obviously without going back to stock because the power gain is notable)