• 4 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     TE = 4st Enduro & TC = 4st Cross

  • Hi everyone,

    As you all know, Coffee (Dean) passed away a couple of years ago. I am Dean's ex-wife's husband and happen to have spent my career in tech. Over the years, I occasionally helped Dean with various tech issues.

    When he passed, I worked with his kids to gather the necessary credentials to keep this site running. Since then (and for however long they worked with Coffee), Woodschick and Dirtdame have been maintaining the site and covering the costs. Without their hard work and financial support, CafeHusky would have been lost.

    Over the past couple of weeks, I’ve been working to migrate the site to a free cloud compute instance so that Woodschick and Dirtdame no longer have to fund it. At the same time, I’ve updated the site to a current version of XenForo (the discussion software it runs on). The previous version was outdated and no longer supported.

    Unfortunately, the new software version doesn’t support importing the old site’s styles, so for now, you’ll see the XenForo default style. This may change over time.

    Coffee didn’t document the work he did on the site, so I’ve been digging through the old setup to understand how everything was running. There may still be things I’ve missed. One known issue is that email functionality is not yet working on the new site, but I hope to resolve this over time.

    Thanks for your patience and support!

how to set throttle stop te 310 r

Jodi

Jodi

Husqvarna
B Class
hello,

my throttle stop screw isn`t correct adjusted. how many turns is it normally in? How is the correlation between tps sensor and throttle stop screw.

thanks a lot in advance and sorry for my english

achim
 
Boogie said:
Where is the throttle stop screw?...
Click to expand...


I believe he is talking about the idle speed/cold start knob.

Jodi said:
hello,

my throttle stop screw isn`t correct adjusted. how many turns is it normally in? How is the correlation between tps sensor and throttle stop screw.

thanks a lot in advance and sorry for my english

achim
Click to expand...

the manual says 34 clicks out (not turns), from all the way in, to get 1950rpms... and most people are finding they need 38+ clicks. it's on Pg D.9 (39) of the 2013 WSM which you can find here

the manual is wrong on the turn-direction (in general, it's a very poor translation to english, if you could find a factory manual in german it'd probably be better.)

other manuals are here.

your english is great. good luck.
 
About 2.2mm from the nut to the end of the screw, however, I wouldn't set it with a measurement.

Wind it out. Make sure the throttle is closed (butterfly fully closed). Wind the stop screw back in until it just touches. Go 1/2 turn more and lock it up.
 
Hey Jodi-
where did you get that image of the throttle body? is there anymore? (I'm assuming you did not take the photo- or did you?). I'd like to learn about the Keihin TBI as much as possible. If you have taken a look at the manual, it is suprisingly sparse.

thanks.
 
top throttle stop (cable pulley) is 8.0mm and the bottom throttle stop (throttle plate) is 9.4mm. The measurement is from the top of the threaded boss to the stop on the pulley; calipers are off just to show the measurement. I measured a fairly clean, low hour 2014 TXC TB.

top stop is 8.0mm 20180501_021942.jpg



bottom stop is 9.4mm 20180501_022147.jpg
 
You must log in or register to reply here.
Back
Top