Old Geezer
Husqvarna
A Class
Need some advice on detonation causes in my old two stroker. Just out of the blue one day, it started what sounds like detonation when under a heavy full throttle load. Internal engine rattling/pinging and loss of power.
CDI and coil is working fine (even swapped out with a spare to make sure), new carburetor has maybe 30 hours on it (I took apart and cleaned anyway and checked float setting), pulled the jug and piston and rings and bore all look fine. Thought maybe it was leaning out through a bad engine seal, so replaced both. New tank of gas, mixed 32:1 as always, fuel filter flows freely, air cleaner is clean, changed the plug. Still, detonation and loss of power when I open her up. This bike has been a very consistent performer, jetted just perfectly....but now something is amiss.
What the heck is going on here?! Could perhaps the ignition timing (stator) be giving me problems, or maybe I've got a hot piece of glowing carbon causing pre-ignition...maybe a long shot.
Any ideas would be much appreciated!!
Mark
CDI and coil is working fine (even swapped out with a spare to make sure), new carburetor has maybe 30 hours on it (I took apart and cleaned anyway and checked float setting), pulled the jug and piston and rings and bore all look fine. Thought maybe it was leaning out through a bad engine seal, so replaced both. New tank of gas, mixed 32:1 as always, fuel filter flows freely, air cleaner is clean, changed the plug. Still, detonation and loss of power when I open her up. This bike has been a very consistent performer, jetted just perfectly....but now something is amiss.
What the heck is going on here?! Could perhaps the ignition timing (stator) be giving me problems, or maybe I've got a hot piece of glowing carbon causing pre-ignition...maybe a long shot.
Any ideas would be much appreciated!!
Mark