250-500cc Deja vu. WRK250 back to how it was in 1999

[juicypips]

As previously stated a Heli coil kit or timesert the holes its easy man,
You buy a kit and do all at the same time, best part is you effectively have a ten mill thread holding into the ali an your m8 go into the steal insert.

Really the only option.

 

[rancher1]

As previously stated a Heli coil kit or timesert the holes its easy man,
You buy a kit and do all at the same time, best part is you effectively have a ten mill thread holding into the ali an your m8 go into the steal insert.

Really the only option.

Good answer !

 

[juicypips]

The material it removes wont be much, and i can promise it will hold compared to jb weld.
If your worried about tapping a thread drill the holes out to the next sized spacer and slam them in an bolt through the lot.

 

[shawbagga]

Yes^ that's what I'd do. Easier too

 

[CastorCalogne2]

Thanks guys. Will mark out the hub holes so I know for sure what play I'm dealing with. It looks worse than it is.

Titman were skeptical about doing it, I don't blame them. If it fuked out their name would be on the job.

Will do a few practice runs on scrap.

Cheers

 

[juicypips]

If you were in the uk i would do it for you, have helicoils in my draw.