2013 TE310 Sprockets

[MasterChief]

I had an Ironman 45 tooth for my 610 that I never installed, so I put that on the 310.

Now I'm looking for a 12 tooth front, so I can gear down for single track and up a little for forest roads etc.

I can't find a 12 t that fits.

Anyone else running one or know where I can get one?

 

[PALMER84ONE]

Try Kelly at Motosportz.


http://www.motosportzhusqvarna.com/Husqvarna X-Lite TE, TC, TXC, 250, 310.htm

 

[MasterChief]

Thanks, I'll give them a call.

I've had two so far from the dealer that have not fit.

Is the 2013 countershaft different than earlier models?

 

[Freaky]

Yes, x-lite front spockets are different to the earlier models, must be a 2010 onwards.

 

[reveille]

Slight thread hijack Will a 14t fit on a 2012 TE310? I have a 50T rear and 13t CS and thought a 14t CS might be a nice option for open single track and forest access roads. Should help to extend chain life as well. And very easy to swap between a 13 to a 14t without modifying the chain. Putting a 12t on would really be working the motor and causing accelerated chain wear IMHO

 

[MasterChief]

Slight thread hijack Will a 14t fit on a 2012 TE310? I have a 50T rear and 13t CS and thought a 14t CS might be a nice option for open single track and forest access roads. Should help to extend chain life as well. And very easy to swap between a 13 to a 14t without modifying the chain. Putting a 12t on would really be working the motor and causing accelerated chain wear IMHO

I doubt a 14t will fit, it's pretty tight with the stock 13t. If anyone has actually done it please let us know.

You may be right about the chain wear with a 12t, but I'm not sure I understand why that would make the motor work harder than the same ratio obtained with a larger rear sprocket.

 

[Mike-AK]

I had an Ironman 45 tooth for my 610 that I never installed, so I put that on the 310.

Now I'm looking for a 12 tooth front, so I can gear down for single track and up a little for forest roads etc.

I can't find a 12 t that fits.

Anyone else running one or know where I can get one?

I've got a 49 tooth Ironman with about 5 miles on it that I will be putting up for sale in the classifieds. It would be almost the same as dropping a tooth on the front. I found it was not low enough for my needs, so I have a 52 tooth Ironman on order. As soon as the new sprocket gets here, I'll post the old one for sale.

 

[MasterChief]

I've got a 49 tooth Ironman with about 5 miles on it that I will be putting up for sale in the classifieds. It would be almost the same as dropping a tooth on the front. I found it was not low enough for my needs, so I have a 52 tooth Ironman on order. As soon as the new sprocket gets here, I'll post the old one for sale.

The problem with this idea is that I would have to install a 14t front to gear up. I'm not sure that would work.

 

[MasterChief]

Try Kelly at Motosportz.


http://www.motosportzhusqvarna.com/Husqvarna X-Lite TE, TC, TXC, 250, 310.htm

Thanks for the link. I got the 12t from Mike @ motosports. With the 12 and 45 it was much better on the trail. But, I may still go lower