Husky 450TE Tail light mod.

Just decided i needed to go the Pooratech way with my Husky 2007 TE Tail light. This is what i did with some scrap Aluminium i found in my workshop and some LED's i had.



Fits nicely under the mudguard and i drilled holes afterwards for the number plate to fit.



The price was right--Zero

Very nice. I cut a scrap of aluminum to fit under the fender to hide all the wires. It bolted up to the sub-frame, through the holes for a trail rack. No pic yet.

Sounds like a good plan to meNeed to get back to the drfawing board and also look at that.

Looks very clean.
How did you get rid of the stock mount?

Last pic is of the aluminum cover for electricals under fender.

http://gallery.me.com/glangston1#100024

Looks very nice. Just yesterday I decided to give up on turn signals as the woods are always trying to take them anyway. So, removed the entire rear bracket support for them and pulled the wiring back under the seat and shrink wrapped it all and tucked it away.

Similar idea as glangston for protecting tail wires, my partner used a piece cut from a mudflap, slid right over the "H" support, and held in place with a yellow zip tie for easy removal.
Not being metal fabricators, we use this plastic for a lot of things, including biff-proof holders for the led turn signals.

good info here guy. Also, interesting to see you guys have the same mud flaps we do. Hey, wait a minute...did you get that off MY truck???