2013 TXC 250R front brake rebuild parts needed

My 2013 txc 250R need the front master brake cylinder rebuilt.
I need the piston and seal kit, but husky only lists a complete master cylinder for over 250 bucks.

Any one know the correct part to buy to rebuild the front master cylinder? I'm sure it's the same as something out there, just don't want to guess.

Call Bills- they should know exactly what Brembo rebuild kit you need and get it to you fast.

Yeah, you don't need a Husky part, you need a Brembo part.

They list everything for the rear separately, but not the front

I think I just need to figure our which size bore it is to get the 4ight brembo seal.

From what I can find out I think 12mm

Sometimes Ktm sold them parts individually.

I needed a rear caliper piston and sized it up through ktm instead husky having to buy whole caliper.

That's what the parts guy at bills told me too.

Hey Matthew525, did you ever find the right parts for your husky? I am looking for a front brake master rebuild for my 09' TE310...I am going to measure the piston sometime this week and see if I can find the corresponding KTM part. But if you found one that works, that would help me out. Thanks!

Dan

I had a stuck caliper piston and Bill's sent me the correct Brembo parts to rebuild with

I just got a genuine brembo rebuild kit off the Internet. It's been a while. I can't remember for sure but I think it was a 12mm brembo piston kit. It's been almost a year and a kid later, my memory may be slippin.

Thanks for the response guys. In my case, the master was a 10mm and is the exact same part as KTM 54813008200. Same numbers on the piston and everything. btw my bike is a 2009/10 TE 310.

-Dan