250-500cc 1995 WR 360 parts

I haven't acquired the bike yet. But Im a little concerned about engine wearable parts availability..
Is it because it was produced by Cagiva?
There seems too be more parts available for the 1970s Husqvarna..

Should I tread carefully..

I can bail out while I can

Tell me to take a deep breath and relax

Thanks

as of late the parts are more diicult to come up with
FYI the 360 was 1992-2002
1992 used a differs exhaust port
92-94 is the same frame, plastic etc.
95-99 is the same frame and plastic will interchange as well as pipe and silencer, seat etc
00-20 share parts too
96 or 97 the changed the porting for more low end but all parts fit

I am seeing that Pistons and Con Rods and bearings kits are not available if I need one..why?

Maybe there are substitutes if I measure the parts?

Im seeing some kits on Ebay made and shipped from Taiwan..for about 140 bucks?

Am I not being smart? Im sure the rod itself dent usually go bad. But big and small end needle bearings probably do

Ill keep looking on our forum for answers

look up Wossner pistons
and the Taiwan rods are fine
FYI it shares a rod with KTM, but the lower pin is longer on Husky

I sent you a private conversation
Thanks

I think wossner also makes rod kits

they do but not for the 360
the KTM 380 rod is the same but the lower pin is a bit shorter on the KTM
Royal Rods in Taiwan did make one not sure if they still do

https://www.royalrods.com.tw/products/products-302-30.html

Hi, if you need parts for 360 I have many in stock, please send me a list in private or for my e-mail ecbike@ecbike.pt
thanks