• Hi everyone,

    As you all know, Coffee (Dean) passed away a couple of years ago. I am Dean's ex-wife's husband and happen to have spent my career in tech. Over the years, I occasionally helped Dean with various tech issues.

    When he passed, I worked with his kids to gather the necessary credentials to keep this site running. Since then (and for however long they worked with Coffee), Woodschick and Dirtdame have been maintaining the site and covering the costs. Without their hard work and financial support, CafeHusky would have been lost.

    Over the past couple of weeks, I’ve been working to migrate the site to a free cloud compute instance so that Woodschick and Dirtdame no longer have to fund it. At the same time, I’ve updated the site to a current version of XenForo (the discussion software it runs on). The previous version was outdated and no longer supported.

    Unfortunately, the new software version doesn’t support importing the old site’s styles, so for now, you’ll see the XenForo default style. This may change over time.

    Coffee didn’t document the work he did on the site, so I’ve been digging through the old setup to understand how everything was running. There may still be things I’ve missed. One known issue is that email functionality is not yet working on the new site, but I hope to resolve this over time.

    Thanks for your patience and support!

Setting up Lectron

robj

robj

Husqvarna
AA Class
Hi - I'm trying out the Lectron 36 on my aircooled KDX200 project bike. I'm tuning it with the 3.2XL. Because i switched metering rods, it's taken me a little while to get it into the 'zone'. I've got it now so that it idles and the revs pull cleanly off the bottom. The only thing is that when you blip the throttle the revs don't drop back down to idle for about 30 seconds, then it settles. Is this a standard lean condition? or likely some other issue? Thanks for any input.
 
sounds like its a bit lean perhaps, as it should only take a few seconds..fyi im also running that same rod in my 360 with a 38mm..
when you say it idles high, is it just barely higher then settles? i have mine tuned to where it part throttle four stroked a very small amount, then leaned a half turn on the rod..
if you do have a lean condition you may have something else causing it..
 
That's a pretty rich rod, so it's adjusted lean or you have an air leak. Both my Lectrons came with the rod @ 49mm, so I'd say that's a good reference/starting point.
 
You must log in or register to reply here.
Back
Top