Hi am a new TE 250 owner. i am trying to figure out which wire is positive for the 2006 250. There is a blue and a sky blue wire. Any one know which one is positve. I had tried to test with a multimeter but did something wrong and smoked the fuse. Original owner cut off quick connect. I have purchased the sacass flat mount leds. I am mounting them on the fender. I alsodont know which wire I should connect the positive line to on the led. They are black and red. Any info greatly appreciated.
-
Hi everyone,
As you all know, Coffee (Dean) passed away a couple of years ago. I am Dean's ex-wife's husband and happen to have spent my career in tech. Over the years, I occasionally helped Dean with various tech issues.
When he passed, I worked with his kids to gather the necessary credentials to keep this site running. Since then (and for however long they worked with Coffee), Woodschick and Dirtdame have been maintaining the site and covering the costs. Without their hard work and financial support, CafeHusky would have been lost.
Over the past couple of weeks, I’ve been working to migrate the site to a free cloud compute instance so that Woodschick and Dirtdame no longer have to fund it. At the same time, I’ve updated the site to a current version of XenForo (the discussion software it runs on). The previous version was outdated and no longer supported.
Unfortunately, the new software version doesn’t support importing the old site’s styles, so for now, you’ll see the XenForo default style. This may change over time.
Coffee didn’t document the work he did on the site, so I’ve been digging through the old setup to understand how everything was running. There may still be things I’ve missed. One known issue is that email functionality is not yet working on the new site, but I hope to resolve this over time.
Thanks for your patience and support!
Rear turn signals for 2006 TE 250
- Thread starter davidson
- Start date
timmygrant08
Husqvarna
B Class
Blue / Sky blue is left
Black and red is Right
Black and red is Right
Get your multimeter out again and make sure red lead is plugged into + and black lead is into -. Set range to DC and closest range to 12V. Place red lead to one of signal light wires and black to other and turn on signal light switch. Multimeter should pulse up if polarity correct or down if reversed. Fiddle with leads until wire on red lead pulses up. This will be your + wire for led.