1. 4 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     TE = 4st Enduro & TC = 4st Cross

Weld a Pinhole in the Stator Cover

Discussion in '4 Stroke' started by Jim S, May 21, 2017.

  1. Jim S Husqvarna
    AA Class

    Location:
    Orange County , CA
    Husqvarna Motorcycle:
    2013 TE310R
    Other Motorcycles:
    Yamaha FJR 1300
    Is it possible to weld the stator cover? I have a tiny crack. How much should that cost? A replacement cover is around $100.
    Jim S, May 21, 2017
    #1

  2. norma stitz Husqvarna
    A Class

    Husqvarna Motorcycle:
    SMR511
    Other Motorcycles:
    Nunya185
    JB weld is your friend.
    norma stitz, May 21, 2017
    #2
    Flash319 likes this.

  3. Jim S Husqvarna
    AA Class

    Location:
    Orange County , CA
    Husqvarna Motorcycle:
    2013 TE310R
    Other Motorcycles:
    Yamaha FJR 1300
    J-B WELD twin tube two part mix or 7901 Extreme Heat High Temperature Resistant Metallic Paste or Steelstik epoxy putty stick?
    Jim S, May 21, 2017
    #3
    OlderHuskyRider likes this.

  4. koth442 Husqvarna
    A Class

    Location:
    Rolla Missouri
    Husqvarna Motorcycle:
    SM610
    Other Motorcycles:
    Yamaha FJ-09
    Pick one. The engine cases don't exceed temperatures that basic JB Weld is rated for.
    koth442, May 21, 2017
    #4

  5. Trenchcoat85 Husqvarna
    Pro Class

    Location:
    Northern NorCal
    Husqvarna Motorcycle:
    '14 TE 310R
    Other Motorcycles:
    '85 shovel, '75 DT400, '97 XR400
    JB Weld- works beautifully, and as it starts to take-off you can smooth and form it with a wet finger. If you have aluminum chunks from the crack (doesn't sound like you do) put them back in place.

    get the regular pack of J-B Weld.

    good luck.
    Trenchcoat85, May 21, 2017
    #5
    OlderHuskyRider likes this.

  6. Matthew525 Husqvarna
    AA Class

    Location:
    New Berlin, WI
    Husqvarna Motorcycle:
    2013 TXC 250R
    Other Motorcycles:
    KTM 525, HONDA CRF150
    If you decide to buy a new stator cover, don't forget the bearing. It isn't seen I the same diagram as the cover, but it is seen in the left crank case half diagram. In that view the stator cover is seen, but not identified.
    Matthew525, May 24, 2017
    #6