1. 4 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     TE = 4st Enduro & TC = 4st Cross

Valve Cover breather hose

Discussion in '4 Stroke' started by columbia510, Jun 8, 2009.

  1. columbia510 Husqvarna
    AA Class

    Location:
    columbia,ca
    My 07 510 breather hose popped out of my valve cover. Don't know how much oil was still in the motor or how much was on my right leg.:doh:
    Any cures for this, its happened before and I just JB'd the fitting back into the valve cover.
    columbia510, Jun 8, 2009
    #1

  2. Dirtdame Administrator

    Location:
    Rock Springs Wy
    Husqvarna Motorcycle:
    11 WR300,13 WR125,18 FE501
    Other Motorcycles:
    17 Beta Xtrainer
    I use a high temp silicone RTV on most parts and surfaces of engines, so I used some on my breather fitting and it held till I had to remove the cover for valve inspection. Seem like I have been recommending it for a lot of things on this site lately, but it is very versatile. I have a couple of two stroke bike that doesn't have any center case gaskets, and I always use that stuff on a rebuild. It works on a lot of stuff.:thumbsup:
    Dirtdame, Jun 8, 2009
    #2