1. Husqvarna Motorcycles Made In Sweden - About 1988 and older

torque settings

Discussion in 'Vintage Restoration Projects' started by MikeDi, Jan 20, 2018.

  1. MikeDi Husqvarna
    AA Class

    Location:
    U.S.A. New England
    Husqvarna Motorcycle:
    1983 WR 430
    Other Motorcycles:
    Stuck in the 80's vintage
    Looking for torque settings for primary gear nut and flywheel nut.
    84 WR250
    thanks Mike
    MikeDi, Jan 20, 2018
    #1

  2. silverstreakNZ Husqvarna
    Pro Class

    Location:
    Christchurch nz
    Husqvarna Motorcycle:
    82cr500,76gp360,90wr250,81 420AXC
    Other Motorcycles:
    74 tm400 , 02 gasgas ec 300
    For a what ?
    silverstreakNZ, Jan 21, 2018
    #2

  3. Crashaholic Husqvarna
    Pro Class

    Location:
    Antelope Valley, CA.
    Husqvarna Motorcycle:
    73 450WR 6spd motor in a 75 MK frame
    The Sem flywheel is 50Nm (37 ft. lbs.) and the Motoplat is 70Nm (50 Ft. lbs). I've never seen the torque spec documentation for a Husky primary gear but seeing its bigger than the flywheel and is the main transfer of hp I would go higher than the flywheel recommendation.

    If you want confirmation ask a couple of reputable vintage Husky restorers like Vintage Husky, or PM George at Up-tite.

    Attached Files:

    Crashaholic, Jan 21, 2018
    #3

  4. MikeDi Husqvarna
    AA Class

    Location:
    U.S.A. New England
    Husqvarna Motorcycle:
    1983 WR 430
    Other Motorcycles:
    Stuck in the 80's vintage
    thank you!
    MikeDi, Jan 22, 2018
    #4