Going to check out one of these to see if it will clip to the top of the number plate and provided a little bit of wind protection to the upper body without introducing too much turbulence to the helmet area, and also keep wind/bugs off my phone/gps. http://www.givi.it/screens-spoilers/Aerodynamic-protection/S180T SHIELD Anyone try one of these? It looks like there may be just enough room between the instruments and the number plate to fit the clamp in.
Ktm 690 screen works very well and looks like it was made for it. http://www.cafehusky.com/threads/630-tci-windshield.36473/#post-391280
Screensforbikes!!! Fits right on and works great. I used mine on the Trans America Trail this year and can verify it's good!
Thanks - the bottom is shaped to match the top of the light and the middle mounting hole re-drilled a bit higher. Important to mount it with rubber bushes to allow space between the fairing and the screen for laminar air flow (as many know but some not).
I've left to emails over 3 months with screens for bikes without a reply. Not great service. No way to order online.
That's bad news on the screens. A bud and I ordered half a dozen screens and service was good. Still, I will try to snap a pic and post it.
I contacted them through their website and the responded several hours later. Looks like I'm gonna order one from them.
This would be another solution, a bit expensive (€ 130,00 ) but enough strong and protective and the frame can be used as GPS support. Maybe a bit high in offload drive..KIT WINDSCREEN SWM RS 650 R AND SM 650 R (MODELLO SUPERDUAL)