1. Husqvarna Motorcycles Made In Sweden - About 1988 and older

MK and ML Lower Steering Bearing Cup

Discussion in 'Vintage/Left Kickers' started by Vinskord, Jun 20, 2017.

  1. Vinskord Husqvarna
    AA Class

    Husqvarna Motorcycle:
    400 CR
    Is the diameter, as shown in the picture, of the lower steering bearing cup on the 76/7 ML frames the same as for the lower bearing cup for the 72/3/4 MK frames? The OD of the bearings themselves are 40mm for the MK and 50mm for the ML.

    Lower Cup - Copy.jpg
  2. Crashaholic Husqvarna
    Pro Class

    Location:
    Antelope Valley, CA.
    Husqvarna Motorcycle:
    73 450WR 6spd motor in a 75 MK frame


    I don't know however on an MK the area between the arrows in your picture is 34.10mm based on the race from my shelf.
    Vinskord likes this.
  3. Vinskord Husqvarna
    AA Class

    Husqvarna Motorcycle:
    400 CR
    Thanks Crashaholic - much appreciated
  4. jimspac Husqvarna
    Pro Class

    Location:
    Connecticut
    Husqvarna Motorcycle:
    82 250WR, 82 430WR, 84 250WR, 85 400
    Other Motorcycles:
    86 400WR, 82 Montesa Cota 349
    I think the timken cups might fit into the MK frame. A guy here bought timken cups from vintagehusky.com and they fit into the ML frame he was working on.