LED blinkers installed on TE630 now no blinking. What relay is plug and play

I just installed some really bright Baja Designs LED turn signals on the 630. I pretty much expected a fast flash rate but did not expect no flash at all. If you activate the turn signal switch the blinkers light up but don't blink.
Does anyone know of a plug and play turn signal relay for the TE630?
Thanks
Sethro

I think the LED's don't draw enough to get the flashing going.

Here's a link to some info: [URL]http://www.bcsportbikes.com/forum/showthread.php/97431-LED-signal-Lights....what-size-Resistors[/URL]
I believe people add resistors to each side to get enough load to get the flasher thing working.

Better solution would be to buy a new flasher unit made for LED signals. Search locally or Ebay has them for under $2.
http://www.ebay.com/itm/Electronic-...Parts_Accessories&vxp=mtr&hash=item256a8cf1ca

_

Any ELECTRONIC flasher relay should get them to work properly. Take yours to the local auto parts store and compare the plug with an available electronic flasher and you should be fine.

I just found the relay on the bike, it does not look like a normal relay, I will get a pic up here soon

Sethro

Looks like this is what I need

http://sicassracing.com/store/produ.../sicass_smart_flasher_led_turn_signal_flasher

That will work, just you're paying $20 more than you need to. Kingmoochr is correct, any "electronic" flasher will work. Only thermal type flashers (like stock TE630 unit) won't work with LEDs.

_

Just an update on the blinker flasher. It was a direct plug in and installed without any drama, works wonderful.

I think my top speed is higher now also,

Sethro

I had a slightly different issue. Could use some advice.

I installed the bajadesigns LED tail light on my 2008 TE 610. I then installed LED turn signals (rear & with a resistor). But when I did none of the turn signals worked (bike running). Then I went back to the original turn signals to determine whether it was perhaps the LED signals causing all signals to not work. I reinstalled the original turn signals, but still none of them work.

Any thoughts on this? I checked the 5 fuses under the left and right cover. They are all good. And the signals definitely worked before I installed the LED tail light.

Sethro, was that the SICASS Smart Flasher that you ended up with, or something more generic?

Yes thats the one.

Sethro

I do think the LED'S are polarity sensitive. Not positive, but worth a try.

To be clear- do you need one of these LED compatible relays, or two? I'm doing front and rear turn signal conversion to LED

There is only one flasher relay to replace.

BTW, with a LED relay, my led turn signals work as expected, but the turn signal indicator doesn't blink (it does come on)
Anybody else run into this? Not a bit deal, except that it makes it hard to realize you have been riding for miles with a blinker on :-)

Same here. There's no pulsed feedback to the dash.

Ditto, dash blinker does not flash.

Anybody know where to get the quick connectors used on the stock te630 turn signals? I'd like to wire the LED blinkers with OEM male plugs to match the females that came on the bike.

I just robbed them off of the factory indicators. A little tedious, but it works.

Interesting- I was thinking that might be an option, but I hadn't dug one out of there to try that yet.