gaskets and seals

Where is everyone getting engine gaskets and seals from? I'm working on a 75 wr250.

Halls has cometic gaskets, which has some of the best gasket material made - they will have seals also

DC Plastics also has Husqvarna gaskets www.dcvmx.com Gasket King has some as well http://www.gasketking.com/

Be careful if you are considering an Athena gasket kit, lots of them come with no head gasket.
Tony.

I was told there is no head gasket.

Correct ...... there is no head gasket. It is a lapped joint.

Well that makes it easy!

Water cooled bikes have a gasket don't they? Haven't rebuilt one of those yet. Air cooled just lap your head in with valve lapping compound for a good seal

Yep, the water cooled ones sure do have a gasket, and the Athena kits do not include a head gasket in their engine gasket kit.
Kinda dumb?
That would make it a partial gasket kit wouldn't it?
The only logic I can possibly think of is that it is possible to remove the cylinder and head as one assembly without removing the head from the cylinder, personally I prefer to replace old gaskets on any water cooled engine.
Just a heads up for anyone looking for liquid cooled gasket sets, not relevant to this post though!
Tony.

my local dealer has most gaskets, genuine factory for the early models

I get most seals from my local bearing supplier. At a certain point, a seal is a seal...

The workshop manual lists most bearing and seal sizes. Use your local supplier for these. Remember to buy Viton double lip seals for the mains. DO NOT buy budget, spend a bit more on quality. Gasket sets can be had from a few sources in the U.S.

Metric seals Inc. has the viton crank seals they are very nice to deal with also. I think they are in Indiana or something close to there.

Did a total rebuild and Halls had everything I needed. They will spend time on the phone with you to make sure you have exactly what you need.

Hall's also takes PayPal, which is very cool because most of my hobby money comes from other stuff I sell.

Do you have. Link to Halls ? You speak of them lime everyone should know Halls and I don't but need gaskets and seals....please help with a better description or linkage to their shop...thank you in advance..

on the front page site of Cafe Husky they are found under sponsor

http://www.halls-cycles.com

Thank you Sir !