Footrest fitment & years...

I have just tried a set of our footrests on an Aircooled Mono Husky frame from 1985 and they fit! (Not sure about the springs though) This was a surprise to me as I didn't think they would. Can anyone confirm that the other 85 bikes are the same as this for me please? (I think they are all the same...)

We are now working on the computer model for ones to fit from 1986 to 1989..

Thanks in anticipation of your help,

Andy

Both of my 1986 430 autos came with the old style square looking pegs. The 1985 models came with the old style foot pegs. In 1986 most models came with the newer style pegs. I guess the 4 strokes and the autos were the last to get the updated pegs in 1987. Here's my 86 with a new set of IMS pegs made for the earlier twin shock models. They bolted right up, but I did have to file the frame tab a little to them to pivot correctly.

86-88 are different from previous years...the bolt hole goes through at a different angle and they are constructed differently..jim pretty much nailed it with the 86 autos being a holdover from 85. they likely used up the old frames.

Hello Andy,

exactly today I tried your footrest on my 85 (single shock) and yes they fit, just on the left side I had to use the original spring (hole on the frame), the one you provide is a bit different.

(I suspect I will ask you to bring me another pair in Elba :-))

andy, if you could make some pegs that fit the 86-89 bikes i suspect youll find a few buyers. we really have no source of pegs other than custom..

OK guys - thanks for the help. We will proceed to making some rapid prototypes...

Andy

May be of interest - some 86 HD pegs pictured with OEM pegs

lol, never even heard of the hd pegs! nice!

While I do like the HVA factory pegs in the first post and would buy a set for my 86... I really like the design of those IMS pegs.

wheres troy?? hes gotta be foamin at the mouth!

what???? i just got in the door been out watchin the the moon thing

yep foamin hard i just knew Andys would fit but those IMS's OMG

are you paying attention? andys dont fit your bike, we are trying to get him to make some some!

yea i was just glad to see sombuddy do'n sumpin but my Hoover racing products pegs rock

I got Husky Products pegs on my 1986 400WR. I lucked out with that as the bike also came with the HP damping rods in the front forks. It came with the HP expansion chamber as well

First one is on the 3D printer right now!

I'll get you some pics when I can...

Andy

awesome andy, im holding my order till these are ready..

ME TO I THINK MAYBE IDK YOU HAVE A TIME FRAME?

Wouldn't mind seeing a set of rad shrouds for a 1989 WRK250 being done on a 3d printer...