Flywheel puller for a 1976 CR360

Hi, I need to pull the flywheel from this bike.
I think the thread is 27mm diameter - is that correct?. I know the pitch is 1.25mm.
Andy

Motoplat?

yes

Looks like Matt at Speed & Sport has the pullers for Motoplat... 530-878-0700. Or probably Vintage Husky..

OK thanks - I emailed Vintage husky today just to confirm the thread size and pitch..plenty on eBay. Just waiting a response.

just been informed the size is 26mm x 1.25mm pitch

do yourself a favor and gt a Dennis Stubblefield puller..they are much better made...dont get a Chinese one

correction: thread size of puller is 27mm x 1.25mm pitch (not 26mm)

Doesn’t the same puller fit the 390 also?

not sure.....some one here will know for sure..........

Your cr360 has the larger flywheel.?

The later 77 to 1984 external flywheel motoplat puller is M26 x 1.5mm pitch

I pulled my 360wr flywheel using my puller from the 390. It’s the largest husky threaded puller.

Note,,,,when using a puller, before you use it I put moly anti seeze on the pullers threads and run the threaded rod in and out to work it into the threads. It works better than using oil alone. I seen so many pullers gall because of lack of lube.