1. Husqvarna Motorcycles Made In Sweden - About 1988 and older

Flywheel Puller Femsa '72 250wr And Holding Tool

Discussion in 'Vintage/Left Kickers' started by Arthur Smith, Oct 12, 2018.

  1. Arthur Smith Husqvarna
    AA Class

    Husqvarna Motorcycle:
    1972 250 WR
    Other Motorcycles:
    none
    Where can I order/buy this? Thanks.
  2. Michel Dufayard Husqvarna
    Pro Class

    Location:
    France
  3. Kartwheel68 Husqvarna
    Pro Class

    Location:
    Newnan, Georgia
    Husqvarna Motorcycle:
    82 125XC, 250XC, 430XC, 430WR, 250CR
    Other Motorcycles:
    83 175WR , 76 250WR, 74 250 Mag
    The FEMSA puller is, I think, 33x1.5? I dont use a flywheel holder, there are flats on the puller to use an end wrench and I hit the center bolt with an impact.
  4. jimspac Husqvarna
    Pro Class

    Location:
    Connecticut
    Husqvarna Motorcycle:
    82 250WR, 82 430WR, 84 250WR, 85 400
    Other Motorcycles:
    86 400WR, 82 Montesa Cota 349
    I have one my father made when I got my 69 360 Sportsman. I am sure Kartwheel is correct on the size
  5. Crashaholic Husqvarna
    Pro Class

    Location:
    Antelope Valley, CA.
    Husqvarna Motorcycle:
    73 450WR 6spd motor in a 75 MK frame
    Thats correct.

    I'm not sure if its bad to use an impact on a flywheel puller but John at Vintage Husky told me that using one on the crank stub nut was a no no. The vibration can cause the stub to fall out of tolerance. So if theres an alternative to using an impact one may want to go that route instead.