125-200cc Cr125 144cc Kit Pwk Jetting And Kickstart

Upgraded it to a PWK airstriker and its just shooting oil out the tailpipe
I cant get it to idle where it should, it will idle at around 1700 but thats a bit much
im at 42-175 right now with a 6 slide and honda CR250 needle

and where do you find a kick start for one of these that isnt $350?

Jd jetting makes a great kit.

When I looked at their site they had the TMX jet kit but not a pwk 38mm jet kit

You might have to contact them they sell a carb complete for the 125

I'm located at 600' elevation, last ride was 70-85F. My current setup is; FEJ needle 4th clip, 50 pilot, 1.5 turns out, 172 main #7 slide on a PWK 38 airstriker. Jetting is pretty darn good. Should get you in the ball park. This is on the 125 cylinder though, I haven't installed my eric gorr 144 kit yet (it arrived two days after putting in a fresh stock bore topend).

Hi, I have the kick starter from aftermarket, ckeck on my webshop:

https://ecbike.pt/en/motor/51469-kick-starter-lever-husqvarna-125-95-14-ec004.html

Thanks