2013 TC250R valve cover Gasket and Fork Seals.

Well my 2013 TC250r is comin up on about 10 hours or ride time. Getting a lil hard to start sometimes. So thinking maybe time to shim valves. Where can I get a new valve cover gasket. Also what all do I need to take off to time the bike. Will I need stator gasket or clutch cover gasket?

Also I blew a fork seal on my left side. I'm goin to try and clean it out and hopin maybe it's just got dirt in it. But if not I need to order fork seals.

Any special tools I need to order for these to tear them apart? Also where can I order the seals from.

cover seal is a seal, its reusable, as for fork seal always bleed your forks of air and be sure your forks are in proper alignment, these modern seals rarely fail at low hours unless there is a physical cause.