1. 4 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
    TE = 4st Enduro & TC = 4st Cross

2010 Te310 12pt Injector/race Ecu Parts Number?

Discussion in '4 Stroke' started by crenninger, Aug 28, 2018.

  1. crenninger Husqvarna
    AA Class

    Husqvarna Motorcycle:
    none
    Hi everyone,
    I am the joyful new owner of a like new TE310 2010. It has the power up kit installed (50 rear sprocket, O2 eliminated, harness plug and spark arrestor in the exhaust.

    I have been reading plenty of threads on the Race ECU/Injector/ Exhaust tip but everything I find is for the 2011+ model.

    Does anyone could provide a thread with the parts number information for the 2010 model to change the ECU to the race with 12pt injector?

    I am working on the iBeat cable and software.

    I've been searching for 2 days, so either I am not good at it or it's hidden really well somewhere, I bet it's around.

    Thank you!
  2. R_Little Husqvarna
    Pro Class

    Location:
    NJ
    The 2010 TE31o is a different motor than the 2011 onward.

    The 2010 310 has the old motor and there is no Race ECU I know about. the later 12pt ECUs don't work on it.

    Does your motor have a red valve cover or a black valve cover?
  3. crenninger Husqvarna
    AA Class

    Husqvarna Motorcycle:
    none
    it's a red cover with the older motor. It appears that 8000H2002 was the ECU kit at the time.

    If anyone has that kit, I would be curious to know the ECU only part number.
  4. R_Little Husqvarna
    Pro Class

    Location:
    NJ
    I dont remember anyone doing a 12pt conversion on the old big block red head motor.

    I'd just get I-beat and tune it.

    They ran fine stock when tuned.
  5. crenninger Husqvarna
    AA Class

    Husqvarna Motorcycle:
    none
    thank you, I finally got my laptop running Windows 32bits, and I am finishing getting the cable ready. Any pointers on what to follow for a 2010 / old block red head engine?

    thank you
  6. R_Little Husqvarna
    Pro Class

    Location:
    NJ
    Look in the Carb/EFI section of this site.

    Your bike has additional parameters to see set than the newer ones.

    If I remember correctly the TPS should be set to 100.5% at wide open throttle.
    You have to set the "FB"(?) settings as well as the CO's.

    The later bikes like mine don't have FB settings, and the TPS for later bikes is 102.3%

    Don't confuse the two.

    You may have to look a bit back in the folder to find the older settings since most people here have the newer bikes.

    May search the EFI forum for "FB" or "FB1"
  7. crenninger Husqvarna
    AA Class

    Husqvarna Motorcycle:
    none
    Thank you, I will do more research on that sub-section.
  8. crenninger Husqvarna
    AA Class

    Husqvarna Motorcycle:
    none
    I got I beat running, changed the co2 from 100/100/100 to 115/108/105... test ride this morning!
  9. gradateur Husqvarna
    B Class

    Husqvarna Motorcycle:
    310 TE 2010
    And? Can you tell us tell us what happened next? :cheers: