1. 4 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
    TE = 4st Enduro & TC = 4st Cross

2005 tc250 jetting

Discussion in '4 Stroke' started by Nopo530, Feb 15, 2017.

  1. Nopo530 Husqvarna

    Husqvarna Motorcycle:
    2005 tc250
    I just jetted the bike with a jd kit replaced the 50 pilot with the jd 42 and the 175 main with the jd 185 with the red needle with clip on 5th position from top as recommended also did the leak jet bike seem to run way better low to high but idle is nowhere to be found either its a higher idle or it dies I ride sea level to 4000ft and mostly around 75-100 degrees should I move the clip or mess with the stock air/fuel screw anyone have this problem
  2. Trenchcoat85 Husqvarna
    Pro Class

    Location:
    Northern NorCal
    Husqvarna Motorcycle:
    '14 TE 310R
    Other Motorcycles:
    '85 shovel, '75 DT400, '97 XR400
    No "periods" on your phone or what? wow- that is hard to read.

    anyhooo- I'm not a tc expert by any means... but if your fuel screw is good (all parts present & accounted for; 1-1/2 to 2-1/4 turns out) that needle seems to be awful high (rich).

    hopefully, someone a bit more knowledgeable will tune in.